Включение WI-FI и Bluetooth с Intel® Wireless-AC 9560

Я плохо знаком с этим сайтом и этой ОС "Ubuntu"

таким образом, у меня есть проблемы с Wi-Fi и Bluetooth..

Я просто проверяю журналы и наконец думаю, что проблема связана со встроенным микропрограммным обеспечением..

dmesg | grep iwl
[    2.819550] iwlwifi 0000:00:14.3: loaded firmware version 34.0.0 op_mode iwlmvm
[    2.833065] iwlwifi 0000:00:14.3: Detected Intel(R) Dual Band Wireless AC 9560, REV=0x338
[    7.900012] iwlwifi 0000:00:14.3: Failed to load firmware chunk!
[    7.900015] iwlwifi 0000:00:14.3: iwlwifi transaction failed, dumping registers
[    7.900016] iwlwifi 0000:00:14.3: iwlwifi device config registers:
[    7.900050] iwlwifi 0000:00:14.3: 00000000: 34f08086 00100406 02800030 00800010 17114004 00000060 00000000 00000000
[    7.900051] iwlwifi 0000:00:14.3: 00000020: 00000000 00000000 00000000 00348086 00000000 000000c8 00000000 000001ff
[    7.900052] iwlwifi 0000:00:14.3: iwlwifi device memory mapped registers:
[    7.900086] iwlwifi 0000:00:14.3: 00000000: 00489008 00000040 00000000 00000000 00000000 00000000 00000000 00000000
[    7.900087] iwlwifi 0000:00:14.3: 00000020: 00000011 0c040005 00000332 d55555d5 d55555d5 d55555d5 80008040 001f0040
[    7.900106] iwlwifi 0000:00:14.3: Could not load the [0] uCode section
[    7.900110] iwlwifi 0000:00:14.3: Failed to start INIT ucode: -110
[    7.913089] iwlwifi 0000:00:14.3: Failing on timeout while stopping DMA channel 8 [0x0bad1122]
[    7.925547] iwlwifi 0000:00:14.3: Failed to run INIT ucode: -110

dmesg|grep -i firmware
[    0.261195] pci 0000:00:1f.5: BAR 0: trying firmware assignment [mem 0xfe010000-0xfe010fff]
[    0.827494] [Firmware Bug]: Invalid critical threshold (0)
[    1.719365] psmouse serio1: elantech: assuming hardware version 4 (with firmware version 0x4d5f02)
[    1.997497] iwlwifi 0000:00:14.3: loaded firmware version 34.0.0 op_mode iwlmvm
[    2.313386] Bluetooth: hci0: Minimum firmware build 1 week 10 2014
[    2.314629] bluetooth hci0: Direct firmware load for intel/ibt-19-32-1.sfi failed with error -2
[    2.314631] Bluetooth: hci0: Failed to load Intel firmware file (-2)
[    2.316386] Bluetooth: hci0: Minimum firmware build 1 week 10 2014
[    2.316393] bluetooth hci0: Direct firmware load for intel/ibt-19-32-1.sfi failed with error -2
[    2.316395] Bluetooth: hci0: Failed to load Intel firmware file (-2)
[    3.349840] rtl8192cu: Loading firmware rtlwifi/rtl8192cufw_TMSC.bin
[    7.136131] iwlwifi 0000:00:14.3: Failed to load firmware chunk!

rfkill list all
0: hci0: Bluetooth
    Soft blocked: no
    Hard blocked: no
1: phy1: Wireless LAN
    Soft blocked: no
    Hard blocked: no

моя модель ноутбука hp 15-cs3012tx, и версия Ubuntu является 16.04 LTS, которые я просто искал своей модели адаптера, говорит она

Intel® Wireless-AC 9560 802.11a/b/g/n/ac (2x2) Wi-Fi® и Bluetooth® 5 Combo

таким образом, я просто загрузил встроенное микропрограммное обеспечение intel ac 9560 для установки

1. OVERVIEW

The file iwlwifi-5150-2.ucode provided in this package must be 
present on your system in order for the Intel Wireless WiFi Link
AGN driver for Linux (iwlagn) to operate on your system.

The "-2" in the filename reflects an interface/architecture version number.
It will change only when changes in new uCode releases make the new uCode
incompatible with earlier drivers.

On adapter initialization, and at varying times during the uptime of 
the adapter, the microcode is loaded into the memory on the network 
adapter.  The microcode provides the low level MAC features including 
radio control and high precision timing events (backoff, transmit, 
etc.) while also providing varying levels of packet filtering which can 
be used to keep the host from having to handle packets that are not of 
interest given the current operating mode of the device.

2. INSTALLATION

The iwlagn driver will look for the file iwlwifi-5150-2.ucode using the 
kernel's firmware_loader infrastructure.  In order to function 
correctly, you need to have this support enabled in your kernel.  When 
you configure the kernel, you can find this option in the following 
location:

        Device Drivers ->
                Generic Driver Options ->
                        Hotplug firmware loading support


You can determine if your kernel currently has firmware loader support 
by looking for the CONFIG_FW_LOADER definition on your kernel's 
.config.

In addition to having the firmware_loader support in your kernel, you 
must also have a working hotplug and udev infrastructure configured.  
The steps for installing and configuring hotplug and udev are very 
distribution specific. 

Once you have the firmware loader in place (or if you aren't sure and 
you just want to try things to see if it works), you need to install 
the microcode file into the appropriate location.

Where that appropriate location is depends (again) on your system 
distribution.  You can typically find this location by looking in the 
hotplug configuration file for your distro:

    % grep \"^FIRMWARE_DIR\" /etc/hotplug/firmware.agent

This should give you output like:

    FIRMWARE_DIR=/lib/firmware

If it lists more than one directory, you only need to put the 
microcode in one of them.  In the above example, installation is 
simply:

    % cp iwlwifi-5150-2.ucode /lib/firmware

You can now load the driver (see the INSTALL and README.iwlwifi provided with
the iwlwifi package for information on building and using that driver.)

это - приложенный документ с микропрограммным файлом

Я ввел команду, и она показала как это

grep \"^FIRMWARE_DIR\" /etc/hotplug/firmware.agent
grep: /etc/hotplug/firmware.agent: No such file or directory

но в документе это, как предполагалось, было похоже на это

% grep \"^FIRMWARE_DIR\" /etc/hotplug/firmware.agent

This should give you output like:

    FIRMWARE_DIR=/lib/firmware

Я не могу установить это встроенное микропрограммное обеспечение с путем выше.. и я думаю, что эти 9 650 устройств связаны с Wi-Fi и Bluetooth..

мог кто-то давать мне руку для установки этого встроенного микропрограммного обеспечения..?

спасибо за Вашу руку заранее

редактирование) я также включал журналы с командой dmesg|grep -i firmware