Не удается загрузить RaspberryPi с 19.10 до 20.04 после успешного обновления

У меня Raspberry Pi (3) с установленной Ubuntu 19.10 arm64. Я успешно обновил его до 20.04 с помощью do-release-upgrade , а затем перезапустил. Ничего. Это не проходит радужную графику. Однако это не проблема с 20.04, потому что, если я прошью образ 20.04 на карту, проблем не будет. В чем может быть проблема с обновлением?

0
задан 7 June 2020 в 01:31

1 ответ

Ответ таков: установщик ОС Ubuntu не обновляет файл config.txt в / boot / firmware (раздел system-boot ) - он обновляется между выпусками, но, очевидно, не установщиком во время обновления (хотя ОС ожидает этого). Это означает, что после обновления он больше не действителен, и система не может загрузиться.

20.04 выглядит следующим образом:

# Please DO NOT modify this file; if you need to modify the boot config, the
# "usercfg.txt" file is the place to include user changes. Please refer to
# the README file for a description of the various configuration files on
# the boot partition.

# The unusual ordering below is deliberate; older firmwares (in particular the
# version initially shipped with bionic) don't understand the conditional
# [sections] below and simply ignore them. The Pi4 doesn't boot at all with
# firmwares this old so it's safe to place at the top. Of the Pi2 and Pi3, the
# Pi3 uboot happens to work happily on the Pi2, so it needs to go at the bottom
# to support old firmwares.

[pi4]
kernel=uboot_rpi_4.bin
max_framebuffers=2

[pi2]
kernel=uboot_rpi_2.bin

[pi3]
kernel=uboot_rpi_3.bin

[all]
arm_64bit=1
device_tree_address=0x03000000

# The following settings are "defaults" expected to be overridden by the
# included configuration. The only reason they are included is, again, to
# support old firmwares which don't understand the "include" command.

enable_uart=1
cmdline=nobtcmd.txt

include syscfg.txt
include usercfg.txt

Очевидно, это необходимо обновить после того, как вы обновите ОС, но до вы перезагрузитесь. Если вы этого не сделаете, вы всегда можете сделать это вручную с SD-картой, и она все равно будет работать нормально.

0
ответ дан 19 June 2020 в 21:29

Другие вопросы по тегам:

Похожие вопросы: