Режим соединения NIC 6 (баланс-альб) использует только один NIC

ОС: Ubuntu 12.04LTS

bonding в /etc/modules для автоматической загрузки при загрузке

Конфигурация соединения работает в bond-mode 0, но не в bond-mode 6

-

Когда система загружается bond0, появляется только eth0 в качестве ведомого

eth1 вообще не работает в ifconfig, но может быть вызвано ifconfig eth1 up

Однако, даже после того, как оно поднято, оно не порабощено bond0

Попытка использовать ifenslave bond0 eth1 приводит к сообщениям системного журнала Master 'bond0', Slave 'eth1': Error: Enslave failed

, что bonding: bond0: Error: dev_set_mac_address of dev eth1 failed!

Однако я могу использовать ifconfig eth1 hw ether 123456789abc для установки mac-адреса на адаптере (работает как на eth0, так и на eth1)

bond0     Link encap:Ethernet  HWaddr <mac address>
          inet addr:10.3.0.1  Bcast:10.255.255.255  Mask:255.0.0.0
          inet6 addr: fe80::222:68ff:fe39:83c0/64 Scope:Link
          UP BROADCAST MASTER MULTICAST  MTU:1500  Metric:1
          RX packets:10519 errors:0 dropped:0 overruns:0 frame:0
          TX packets:9444 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:2179485 (2.1 MB)  TX bytes:1158406 (1.1 MB)

eth0      Link encap:Ethernet  HWaddr 34:56:78:9a:bc:de     <-- set using ifconfig
          UP BROADCAST SLAVE MULTICAST  MTU:1500  Metric:1
          RX packets:10519 errors:0 dropped:0 overruns:0 frame:0
          TX packets:9444 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:2179485 (2.1 MB)  TX bytes:1158406 (1.1 MB)
          Interrupt:17 

eth1      Link encap:Ethernet  HWaddr 12:34:56:78:9a:bc    <-- set using ifconfig
          inet6 addr: fe80::1034:56ff:fe78:9abc/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:3417 errors:0 dropped:0 overruns:1 frame:0
          TX packets:63 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:689886 (689.8 KB)  TX bytes:28363 (28.3 KB)
          Interrupt:20 Base address:0xe800 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:306 errors:0 dropped:0 overruns:0 frame:0
          TX packets:306 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:76193 (76.1 KB)  TX bytes:76193 (76.1 KB)

lo:1      Link encap:Local Loopback  
          inet addr:172.16.1.1  Mask:255.255.255.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1

Вот мой /etc/network/interfaces:

auto lo lo:1 br0
iface lo inet loopback

auto he-ipv6
iface he-ipv6 inet6 v4tunnel
  endpoint 209.51.161.14
  address 2001:470:1f06:4ca::2
  gateway 2001:470:1f06:4ca::1
  netmask 64
  local 10.3.0.1
  up ip -6 route add default dev he-ipv6
  down ip -6 route del default dev he-ipv6

iface lo:1 inet static
  address 172.16.1.1
  netmask 255.255.255.0
  network 172.16.1.0

auto eth0
  iface eth0 inet manual
  bond-master bond0

auto eth1
  iface eth1 inet manual
  bond-master bond0

auto bond0
iface bond0 inet static
  address 10.3.0.1
  netmask 255.0.0.0
  gateway 10.0.0.1
  bond-mode 6
  bond-miimon 100
  bond-lacp-rate 1
  bond-slaves none

ethtool ethX вывод:

Settings for eth0:
    Supported ports: [ TP ]
    Supported link modes:   10baseT/Half 10baseT/Full 
                            100baseT/Half 100baseT/Full 
                            1000baseT/Half 1000baseT/Full 
    Supported pause frame use: No
    Supports auto-negotiation: Yes
    Advertised link modes:  10baseT/Half 10baseT/Full 
                            100baseT/Half 100baseT/Full 
                            1000baseT/Half 1000baseT/Full 
    Advertised pause frame use: No
    Advertised auto-negotiation: No
    Speed: 100Mb/s
    Duplex: Full
    Port: Twisted Pair
    PHYAD: 0
    Transceiver: internal
    Auto-negotiation: on
    MDI-X: Unknown
    Supports Wake-on: pg
    Wake-on: g
    Current message level: 0x000000ff (255)
                   drv probe link timer ifdown ifup rx_err tx_err
    Link detected: yes


Settings for eth1:
    Supported ports: [ TP MII ]
    Supported link modes:   10baseT/Half 10baseT/Full 
                            100baseT/Half 100baseT/Full 
    Supported pause frame use: No
    Supports auto-negotiation: Yes
    Advertised link modes:  10baseT/Half 10baseT/Full 
                            100baseT/Half 100baseT/Full 
    Advertised pause frame use: No
    Advertised auto-negotiation: Yes
    Link partner advertised link modes:  10baseT/Half 10baseT/Full 
                                         100baseT/Half 100baseT/Full 
    Link partner advertised pause frame use: Symmetric
    Link partner advertised auto-negotiation: Yes
    Speed: 100Mb/s
    Duplex: Full
    Port: MII
    PHYAD: 24
    Transceiver: internal
    Auto-negotiation: on
    Supports Wake-on: g
    Wake-on: d
    Current message level: 0x00000001 (1)
                   drv
    Link detected: yes